iRad 1000/1 High Voltage Multimeter DVM Adapter High Quality w/Calibration Pot

Description

The iRad 1000/1 High Voltage Multimeter Adapter Box is an extremely accurate and high quality 1 GigaOhm 1% resistance device, that when used in combination with your Multimeter, allows the measurement of High Voltages at a 1000 to 1 ratio with excellent accuracy (as measured on your multimeters standard voltage scale). This is the perfect item to measure the HV on your Survey Meter or other low energy High Voltage devices. Don’t burn out that expensive GM or Scintillator probe by guessing at the voltages. Even if you have a multimeter that reads 1000 volts or higher, don’t try to use it alone without one of these adapters, as your HV reading will most likely not be accurate. Your multimeter will likely read well under the actual voltage if it reads at all, and of course, you risk damage to your multimeter if you try to read voltages higher than it is rated for. Each adapter box leaves my lab calibrated and tested to 2000 volts.
The iRad 1000/1 High Voltage Multimeter Adapter is complete with an adjustable calibration pot accessible through a small opening near the DVM connector. It comes calibrated for most common digital and analog voltmeters with 10meg input impedance, but is capable of calibration to other input impedances, or future recalibration if necessary.
This listing is for a High Voltage Multimeter Adapter with two BNC connectors for the HV / Signal lines, and Banana Connectors for your DVM Multimeter. I can provide a BNC connector instead of the banana connectors for the DVM at no change in cost, or provide different connectors for the HV / Signal lines for a small increase in cost, please inquire before purchase.
This listing is for one iRad 1000/1 High Voltage Multimeter Adapter Box only. No other equipment or cables shown are included in this listing, they are shown only to demonstrate the functionality of the adapter box. The 1000/1 Adapter is shown working with a Ludlum Model 18 at 3 different voltages, and a Model 2200 at voltages to 2000 volts as measured on a calibrated Ludlum Model 500.
Intended for low energy applications only!
The 1000/1 High Voltage Multimeter Adapter is designed to extend the voltage measuring capability of an AC/DC voltmeter to greater than the typical 1000 Volt range of a high end DVM. The 1000/1 Adapter should only be used to make measurements on energy limited circuits within equipment such as found in battery operated survey meters. DO NOT use this device to measure high voltages on power distribution systems. The High Voltage DVM Multimeter Adapter provides high accuracy when used with a voltmeter having 10 MegOhm input impedance (the adapter itself has a high quality 1 GigaOhm 1% resistor network).
I have tons of other radiation detection related equipment listed, so please check out my
other items
.
I
am always adding new items in this category, so please don't forget to add me to your
favorites list
and come back often!
I ship fast, and I guarantee your iRad 1000/1 High Voltage Multimeter Adapter to arrive in excellent condition, or your money back.
Works on Ludlum, Eberline, Bicron, Victoreen, Lionel, CDV, Johnson, and other Survey Meters. For Nuclear Radiation Detection Gamma Spectrometry Spectroscopy, Multichannel Analyzer MCA and Contamination Survey Meter. Also works for GM Geiger Counter Tubes.