New Old Stock RARE - Screw-on Canderra Pancake Probe-Alpha-Beta-Gamma-CDV-700

Description

Unscrew OEM probe and screw this one on!
Low or no use, large eye, Canberra Dover Pancake probe. Detects alpha, beta, and gamma. Swap out factory probe tube with this probe to detect alpha and do high volume sweeps as needed.
G
reat for finding radioactive ore, radioactive debris on beach, rubble, possible contamination of pets, food, people, soil, fish, etc., in high volume / fast paced situations. No calibration needed. This item is a hunter / tracker / forecast piece. Screw-on and go.
Alpha - Although all CDVs can detect beta and gamma, only certain probes detect alpha. When large areas are being scanned, these pancake probes are very fast.
Ready for work! Little if any use. Simply screw on and go!
These are ultra sensitive!! and will not effect calibration when swapped. Calibration mostly applies to the original factory 6993 sensor tube.
Simply remove CDV-700 chrome shield by unscrewing counter clockwise, gently grabbing factory sensor tube inside by the end and wiggle free. Store factory sensor tube inside the factory chrome shield and place tape over the end until needed again.
PS - if chrome shield will not unscrew, open the probe eyelets, then spray a small amount of WD40 down into the bottom through the eyelet hole. Prop up probe in the upright position allowing WD40 to wick down to the rubber seal. Try to remove after 15 minutes. If rubber GM tube becomes damages, I can make you a replacement or you can make one using plumbers putty. I can also free up a stuck probe for you if you cover shipping both ways
.
This is a nice and very rare item! A must for any CDV-700 owner!